Ceiling Fan Remote Not Working Light

You can do this by pointing it towards the camera of your phone and then pressing and holding a button.

Ceiling fan remote not working light.

The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. If you see black or burned areas this may be a sign that your ceiling fan light kit has a wiring issue. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan.

If you have an older ceiling fan the switch may be worn out. Flip the switch several times to make sure it is the right. If the ceiling fan and light works normally then the remote control module will need to be replaced. Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds.

Check whether you have a faulty connection somewhere between the switch fan and circuit breaker. Check the reversing switch. The fan will turn on and light if applicable will blink three times signaling a successful synchronization. This can usually be done by checking the dip switches.

Check whether you have loose ceiling fan wiring. The light bulbs in the fixture are burnt out. Yes the ceiling fan remote control module may be faulty. Follow the steps below to determine the cause.

Should it become necessary to re sync the remote turn off the main power then turn it back on. Check to see whether you have loose switch wiring. The pull chain switches are in the wrong setting. If the remote light up on the camera viewfinder it is working perfectly.

Confirm the reverse switch is not in a neutral position. Screw them into. Other conditions that may prevent a ceiling fan from working. In this case replace the reverse switch.

A short or an overloaded circuit can cause the breaker to trip or turn off. If the fan won t turn on and the lights are working then there is power to the fan. Make sure the switch isn t in between positions. If things look good return light bulbs that are in working order into their sockets.

If no light is visible then it is busted. See the links below to go to the ceiling fan area for detailed photos and instructions. If you are using a remote or. In this case you will need to purchase a new remote and program it for the ceiling fan receiver.